Many glass manufacturers will encounter many different situations in the process of producing products. More cases should be caused by the problem of the glass produced. Sometimes it may be just a little bit of a small flaw. However, sometimes it may directly lead to the destruction of the product, then, to introduce what the manufacturer will encounter.

　　First, many glasses in the market often see some cracks, big or small. This is a defect that many glasses often have, and it is also very dangerous, because some cracks may directly lead to the glass. Fragmentation, only some relatively irresponsible glass manufacturers will bring such products to the market. If it is ours, it is impossible to allow such products to leave the factory. It must be handled internally. Generally speaking, our The specific treatment method is to look at the reflected light, because many cracks are very small, if it is difficult to see under normal sunlight, but according to past experience, cracks are generally more in some places, so Also better to find.

　　Secondly, the common problem on the glass is that the thickness is different. This is also a problem that many glass manufacturers are very troubled. This situation is mainly due to the uneven temperature during the production process because of the production conditions of the glass. It is generally thinner in a place where the temperature is high under uniform high temperature conditions, and the place where the temperature is low is generally thicker. If the temperature on the model of the glass is not the same, it is easy to cause this. A situation.

　　Third, some glass manufacturers will find that many products have been deformed after the production of the product, causing a very large loss. Sometimes, if the temperature is too high, the glass will be deformed, and sometimes the bottle is not completely Cooling, in the process of transmission will encounter something else, resulting in deformation.